电吹风犀牛建模教程-吹风机|Modeling Rowenta Hair Dryer

Now, using the same exact method we did before for shelling, we will make a shell for this dryer part.

Then, we will make one big circle from the center of our little part:

Still in the top viewport, we will Trim off the cap, so we get that round edge and BlendSrf the edges (you can either try JoinEdge command to join broken edges, or you can blend 4 time, and then join everything):



Now, on the back of this part, make a cross section curve like on the image below: Use polyline

And using Sweep2, make a surface:



Then, you can fillet the edges.

Start with ellipse in Right viewport. (Click on diameter option) and input for end of first axis 32mm, and for end of second axis 16mm.



Now, using Rectangle (select Rounded option) make a rectangle (first length 20mm, and second 13mm, and center it in the center of our ellipse:

Rotate the two curves from top viewport, and extrude with no other extrusion options:

Trim the inner part of outer shell of our dryer with extruded ellipse, and split the inner shell of dryer with extruded rounded rectangle:



Loft the edges:

Fillet the Edge with 1mm radius.



Now, create this little rounded rectangle, and position it like on the image:

Project it on the blue surface, and extrude that projected curve by 3mm (-3mm) and make a cap with Patch command.

And for the end, we will make another button. The first one was for controlling the fan speed, and this one is On/Off button. So, create an Ellipsoid

Offset that ellipsoid with OffsetSrf command by 0.5mm towards outside. With the bigger ellipsoid trim the handle:



Fillet the edges with 0.4mm, and you’re done!!!

终于发完了啊！！  [s:44]

向阿抿同志学习！！

呵呵
俺来看看~~~
阿抿在哪找的这好教程？？？

平时不用的命令都有些忘掉了 …………

教程很好！看的很模糊~~~~~~[s:94]

多发点，，，，学习

国外的教材就是不一样，精细

看操作步骤就知道怎么做了[s:80]

都是英语
看不怎么懂

天天有的练习  哈哈 ~~[s:78]

这个不是很难，可以做的出来。

强大的;lz..//

.,.顶个./

非常不错的教程！谢谢！

很不错的教程、、顶一个。。。

[s:74]

不错不错

[s:76] 不错的教程

相当好的 教程    路过的  都不可错过啊[s:67]

[s:78] [s:78]

都是英文~~~~晕死

很好的帖子，學習了